212371
UC500-D1-3K-V7
Ultrasonic sensor
Single head system, Specially for level monitoring in vessels, Large operating voltage range. 10 V DC .. 253 V DC. 20 V AC .. 253 V AC, 3 relay outputs, Series: -D1, Housing: cover: PC, housing: PBT, threaded flange: stainless steel, installation connector/cable socket: PETPfa
| Sensing range: | 60 ... 550 mm |
| Dead band: | 0 ... 60 mm |
| Standard target plate: | 100 mm x 100 mm |
| Transducer frequency: | approx. 380 kHz |
| Response delay: | > 10 s, relay < 1 s, LEDs |
| LED red: | LED 1: overfill indication LED 4: underfill indication |
| LED green/yellow: | LED 2: overfill warning and normal operation LED 3: normal operation and underfill warning |
| DIP switch: | setting of the switch points/operating modes |
| Operating voltage: | 10 ... 253 V DC 20 ... 253 V AC , 47 ... 63 Hz |
| No-load supply current: | < 30 mA with UB = 30 V DC < 110 mA at UB = 10 V DC < 25 mA at UB = 220 V AC |
| Output type: | 3 relay outputs, normally open/closed, selectable |
| Range hysteresis: | 20 mm |
| Contact loading: | 253 V AC/150V DC, 3 A (ohm. load) |
| Life span: | electrical: 105 switching cycles with ohmic load (3 A/253 V AC or 3 A/30 V DC) minimum contact load: 100 µA/100 mV DC mechanical: 20 x 106 switching cycles |
| Temperature influence: | < 4 % |
| Fusing: | ≤ 3 A Slow-blow fuse per output in accordance with IEC 60127-2 Sheet 5 required. Recommendation: after a short circuit, check that the device is functioning correctly. |
| Standard conformity: Standards: | EN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 |
| EAC conformity: | TR CU 004/2011 TR CU 020/2011 TR CU 037/2016 |
| CCC approval: | Certified by China Compulsory Certification (CCC) |
| Ambient temperature: | -20 ... 60 °C (-4 ... 140 °F) |
| Storage temperature: | -40 ... 85 °C (-40 ... 185 °F) |
| Degree of protection: | IP65 |
| Connection: | Female connector, V7 (7-pin), 90° Wire cross section: ≤1.5 mm2 cable diameter ∅7 ... 9 mm |
| Material: Housing: | cover: PC housing: PBT threaded flange: stainless steel installation connector/cable socket: PETP |
| Material: Transducer: | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Mass: | 700 g |
| Note: | In case of loss or damage, the cable socket must be replaced by an identical cable socket (type V7-W) from Pepperl+Fuchs! |
| ECCN: | |
| Country of Origin: | SG |
| EAN: | |
| Weight: | 0.00 kg |
| Length: | 0.00 m |
| Width: | 0.00 m |
| Height: | 0.00 m |