Pepperl+Fuchs
267075-100213
OMT50-R101-2EP-IO-V31-L
Pepperl+Fuchs 267075-100213
OMT50-R101-2EP-IO-V31-L
Distance sensor
Description
Measurement to object, 50 mm detection range, red laser light, laser class 1, measured value via IO-Link, 2 x push-pull output, M8 plug, Miniature design with versatile mounting options, Space-saving distance sensors in small standardized design, Multi Pixel Technology (MPT) - exact and precise signal evaluation, DuraBeam Laser Sensors - durable and employable like an LED, IO-link interface for service and process datafa. The miniature optical sensors are the first devices of their kind to offer an end-to- end solution in a small single standard design — from thru-beam sensor through to a distance measurement device. As a result of this design, the sensors are able to perform practically all standard automation tasks. The DuraBeam laser sensors are durable and can be used in the same way as a standard sensor. The use of Multi Pixel Technology gives the standard sensors a high level of flexibility and enables them to adapt more effectively to their operating environment.
Technical parameters
| Measurement range: | 20 ... 50 mm |
| Reference target: | standard white, 100 mm x 100 mm |
| Light source: | laser diode |
| Light type: | modulated visible red light |
| Laser nominal ratings: Note: | LASER LIGHT , DO NOT STARE INTO BEAM |
| Laser nominal ratings: Laser class: | 1 |
| Laser nominal ratings: Wave length: | 680 nm |
| Laser nominal ratings: Beam divergence: | > 5 mrad d63 d63 < 1 mm in the range of 50 mm ... 250 mm |
| Laser nominal ratings: Pulse length: | 3 µs |
| Laser nominal ratings: Repetition rate: | approx. 3 kHz |
| Laser nominal ratings: max. pulse energy: | 15.2 nJ |
| Angle deviation: | max. +/- 1.5 ° |
| Diameter of the light spot: | approx. 0.5 mm at a distance of 50 mm |
| Angle of divergence: | approx. 0.6 ° |
| Ambient light limit: | EN 60947-5-2 : 30000 Lux |
| Resolution: | 0.01 mm |
| MTTFd: | 560 a |
| Mission Time (TM): | 20 a |
| Diagnostic Coverage (DC): | 0 % |
| Operation indicator: | LED green: constantly on - power on flashing (4Hz) - short circuit flashing with short break (1 Hz) - IO-Link mode |
| Function indicator: | LED yellow: constantly on - switch output active constantly off - switch output inactive |
| Control elements: | Teach-In key |
| Control elements: | 5-step rotary switch for operating modes selection |
| Operating voltage: | 10 ... 30 V DC |
| Ripple: | max. 10 % |
| No-load supply current: | < 25 mA at 24 V supply voltage |
| Protection class: | III |
| Interface type: | IO-Link ( via C/Q = pin 4 ) |
| Device profile: | Smart Sensor |
| Transfer rate: | COM 2 (38.4 kBaud) |
| IO-Link Revision: | 1.1 |
| Min. cycle time: | 3 ms |
| Process data width: | Process data input 3 Byte Process data output 2 Bit |
| SIO mode support: | yes |
| Device ID: | 0x110902 (1116418) |
| Compatible master port type: | A |
| Switching type: | The default setting is: C/Q - Pin4: NPN normally open, PNP normally closed, IO-Link Q2 - Pin2: NPN normally open, PNP normally closed |
| Signal output: | 2 push-pull (4 in 1)outputs, short-circuit protected, reverse polarity protected, overvoltage protected |
| Switching voltage: | max. 30 V DC |
| Switching current: | max. 100 mA , resistive load |
| Usage category: | DC-12 and DC-13 |
| Voltage drop: | ≤ 1.5 V DC |
| Response time: | 2 ms |
| Communication interface: | IEC 61131-9 |
| Product standard: | EN 60947-5-2 |
| Laser safety: | EN 60825-1:2014 |
| Temperature drift: | 20 µm/K |
| Warm up time: | 5 min |
| Repeat accuracy: | ≤ 0.1 mm |
| Linearity error: | ± 0.2 mm |
| UL approval: | E87056 , cULus Listed , class 2 power supply , type rating 1 |
| FDA approval: | IEC 60825-1:2007 Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007 |
| Ambient temperature: | 10 ... 60 °C (50 ... 140 °F) |
| Storage temperature: | -40 ... 70 °C (-40 ... 158 °F) |
| Housing width: | 13.9 mm |
| Housing height: | 41.4 mm |
| Housing depth: | 18.3 mm |
| Degree of protection: | IP67 / IP69 / IP69K |
| Connection: | M8 x 1 connector, 4-pin |
| Material: Housing: | PC (Polycarbonate) |
| Material: Optical face: | PMMA |
| Mass: | approx. 10 g |
Logistic parameters
| ECCN: | |
| Country of Origin: | SG |
| EAN: | |
| Weight: | 0.00 kg |
| Length: | 0.00 m |
| Width: | 0.00 m |
| Height: | 0.00 m |