View this page in: English
Email: "ucnguBrctvdgcxgt0eqo"
Seleccione el idioma
Solicitud con 1 clic
Producto
Pepperl+Fuchs
239920
KT-MB-GT2AD.FF.IO
Solicitar una oferta
Pepperl+Fuchs 239920
KT-MB-GT2AD.FF.IO
Advanced Diagnostic Gateway with Ethernet and FF-H1 Interface and I/O
Bajo pedido. Envíenos un correo electrónico para consultar el precio y la disponibilidad.
"ucnguBrctvdgcxgt0eqo"
Descripción
System integration kit for Advanced Diagnostics, PCS integration via Diagnostic Manager or device DTM, Simple automatic setup of Advanced Diagnostics, Alarm handling and integrated I/O for cabinet monitoring/control, For FOUNDATION Fieldbus and PROFIBUS PApa
Parámetros técnicos
| Design / Mounting: | Motherboard based |
| Rated voltage: | 19.2 ... 35 V DC SELV/PELV |
| Rated current: | 210 ... 120 mA |
| Power dissipation: | max. 4.2 W |
| Fieldbus type: | FOUNDATION Fieldbus |
| Physical layer profile: | profile type 114 |
| ITK version: | 6 |
| Implementation: | resource block 1x RS function block 4x MDI, 1x MDO, 1x MAI, 1x DI transducer block 16x ADM TB, 1x IO TB |
| Firmware update: | Ethernet |
| Polarity: | polarity-sensitive |
| Rated voltage: | 9 ... 35 V SELV/PELV |
| Rated current: | 0 mA |
| Rated voltage: | max. 35 V SELV/PELV |
| Port: | 100 BASE-TX |
| Protocol: | TCP/IP and UDP/IP |
| Services: | ICMP , DHCP , AutoIP , HTTP |
| Connection type: | RJ-45 socket, 8-pin |
| Transfer rate: | 100 MBit/s |
| Connection: | only for the connection to protected circuits |
| Rated voltage: | max. 35 V |
| Number of Diagnostic Bus Channels: | 2 |
| Number of Diagnostic Modules/Channel: | 31 Using Ethernet Interface , 8 Using Fieldbus Interface |
| Termination: | integrated |
| Cable length/Channel: | 30 m |
| LED ERR: | red: Hardware fault |
| LED PWR: | green: Power on |
| Fault signal: | buzzer on |
| LINK/ACT: | yellow |
| CH1, CH2: | yellow: diagnostic bus activity |
| Input I, II: Input type: | selectable: Frequency input , NAMUR/mechanical contact |
| Frequency: Connection: | only passive load |
| Frequency: Rated voltage: | max. 35 V |
| Frequency: Input frequency: | 0.3 Hz to 1 kHz |
| Frequency: Pulse duration: | min. 50 µs |
| Frequency: Accuracy: | ± 1 % |
| Frequency: Cable length: | max. 30 m |
| Frequency: Line fault detection: | lead breakage , short-circuit |
| NAMUR: Sensor type: | NAMUR sensor according to IEC/EN 60947-5-6 |
| NAMUR: Connection: | only passive load |
| NAMUR: Rated voltage: | max. 35 V |
| NAMUR: Switching frequency: | 10 Hz |
| NAMUR: Cable length: | max. 30 m |
| NAMUR: Line fault detection: | lead breakage , short circuit |
| Input III, IV: Input type: | NAMUR/mechanical contact |
| NAMUR: Sensor type: | NAMUR sensor according to IEC/EN 60947-5-6 |
| NAMUR: Connection: | only passive load |
| NAMUR: Rated voltage: | max. 35 V |
| NAMUR: Switching frequency: | 10 Hz |
| NAMUR: Cable length: | max. 30 m |
| NAMUR: Line fault detection: | lead breakage , short circuit |
| Input V: Input type: | selectable: diagnostic bus CH 1 alarm input , NAMUR/mechanical contact |
| Alarm Input: Connection: | only passive load |
| Alarm Input: Rated voltage: | max. 35 V |
| Alarm Input: Cable length: | max. 30 m |
| Alarm Input: Line fault detection: | lead breakage , short circuit |
| NAMUR: Sensor type: | NAMUR sensor according to IEC/EN 60947-5-6 |
| NAMUR: Connection: | only passive load |
| NAMUR: Rated voltage: | max. 35 V |
| NAMUR: Switching frequency: | 10 Hz |
| NAMUR: Cable length: | max. 30 m |
| NAMUR: Line fault detection: | lead breakage , short circuit |
| Input VI: Input type: | selectable: diagnostic bus CH 2 alarm input , NAMUR/mechanical contact |
| Alarm Input: Connection: | only passive load |
| Alarm Input: Rated voltage: | max. 35 V |
| Alarm Input: Cable length: | max. 30 m |
| Alarm Input: Line fault detection: | lead breakage , short-circuit |
| NAMUR: Sensor type: | NAMUR sensor according to IEC/EN 60947-5-6 |
| NAMUR: Connection: | only passive load |
| NAMUR: Rated voltage: | max. 35 V |
| NAMUR: Switching frequency: | 10 Hz |
| NAMUR: Cable length: | max. 30 m |
| NAMUR: Line fault detection: | lead breakage , short circuit |
| Input VII, VIII: Input type: | selectable: Pt100 4-wire temperature input , NAMUR/mechanical contact |
| Temperature: Connection: | only passive load |
| Temperature: Rated voltage: | max. 35 V |
| Temperature: Measurement range: | -50 ... 90 °C (-58 ... 194 °F) |
| Temperature: Accuracy: | 1 K |
| Temperature: Measuring current: | 1 mA |
| Temperature: Lead resistance: | 4.2 Ω per line |
| Temperature: Cable length: | max. 30 m |
| Temperature: Line fault detection: | lead breakage , short-circuit |
| NAMUR: Sensor type: | NAMUR sensor according to IEC/EN 60947-5-6 |
| NAMUR: Connection: | only passive load |
| NAMUR: Rated voltage: | max. 35 V |
| NAMUR: Switching frequency: | 10 Hz |
| NAMUR: Cable length: | max. 30 m |
| NAMUR: Line fault detection: | lead breakage , short circuit |
| Humidity: Measurement range: | 0 ... 95 % RH |
| Humidity: Accuracy: | 2 % RH |
| Humidity: Resolution: | 0.04 % |
| Output I: Output type: | selectable: diagnostic bus CH 1 , relay , NO contact |
| Output I: Contact loading: | 250 V AC/ 6 A resistive load |
| Output I: Mechanical life: | 1 x 105 switching cycles |
| Output I: Response time: | turn-on time 7 ms , turn-off time 3 ms |
| Output I: Switching frequency: | 6 min-1 full load, 1200 min-1 without load |
| Output II: Output type: | selectable: diagnostic bus CH 2 , relay , NO contact |
| Output II: Contact loading: | 250 V AC/ 6 A resistive load |
| Output II: Mechanical life: | 1 x 105 switching cycles |
| Output II: Response time: | turn-on time 7 ms , turn-off time 3 ms |
| Output II: Switching frequency: | 6 min-1 full load, 1200 min-1 without load |
| Output III: Output type: | selectable: common alarm , volt-free contact , NC contact |
| Output III: Connection: | only for the connection to protected circuits |
| Output III: Voltage: | 50 V DC |
| Output III: Current: | max. 1 A |
| Output IV: Output type: | common alarm , buzzer |
| All circuits/FE: | functional insulation acc. to IEC 62103, rated insulation voltage 50 Veff |
| Output I, II/other circuits: | functional insulation acc. to IEC 62103, rated insulation voltage 250 Veff |
| Ethernet/Supply: | functional insulation acc. to IEC 62103, rated insulation voltage 50 Veff |
| Ethernet/other circuits: | functional insulation acc. to IEC 62103, rated insulation voltage 50 Veff |
| Fieldbus/other circuits: | functional insulation acc. to IEC 62103, rated insulation voltage 50 Veff |
| Diagnostic Bus/other circuits: | functional insulation acc. to IEC 62103, rated insulation voltage 50 Veff |
| Electromagnetic compatibility: Directive 2014/30/EU: | EN 61326-1:2013 |
| Low voltage: Directive 73/23/EEC: | EN 61010-1:2010 |
| Galvanic isolation: | IEC 62103 |
| Electromagnetic compatibility: | NE 21 |
| Degree of protection: | IEC 60529 |
| Fieldbus standard: | IEC 61158-2 |
| Climatic conditions: | DIN IEC 721 |
| Shock resistance: | EN 60068-2-27 |
| Vibration resistance: | EN 60068-2-6 |
| Ethernet: | IEEE 802.3 |
| Ambient temperature: | -40 ... 60 °C (-40 ... 140 °F) hazardous area -40 ... 70 °C (-40 ... 158 °F) safe area horizontal DIN rail mounting |
| Storage temperature: | -40 ... 85 °C (-40 ... 185 °F) |
| Relative humidity: | < 95 % non-condensing |
| Shock resistance: | 5 g 11 ms |
| Vibration resistance: | 1 g , 10 ... 150 Hz |
| Pollution degree: | max. 2, according to IEC 60664 |
| Corrosion resistance: | acc. to ISA-S71.04-1985, severity level G3 |
| Housing material: | Polycarbonate |
| Housing width: | see dimensions |
| Housing height: | see dimensions |
| Housing depth: | see dimensions |
| Degree of protection: | IP20 |
| Mass: | 500 g |
| Mounting: | DIN rail mounting |
| FOUNDATION Fieldbus: Connection: | For connection to circuits with safe limited voltage according to IEC 60079-11:2011, type of protection "ic" |
| FOUNDATION Fieldbus: Voltage Ui: | max. 35 V |
| Certificate: | TÜV 14 ATEX 115980 X |
| FOUNDATION Fieldbus: Marking: | Motherboard MB-FB-GT.AD.FF.IO II 3 G Ex nA nC IIC T4 Gc , Gateway II 3 G Ex nA IIC T4 Gc |
| Directive conformity: Directive 2014/34/EU: | EN 60079-0:2012 , EN 60079-11:2012 , EN 60079-15:2010 |
| IECEx approval: | IECEx TUN 14.0003X |
| Directive conformity: Approved for: | Motherboard Ex nA nC IIC T4 Gc , Gateway Ex nA IIC T4 Gc |
| Supplementary information: | Statement of Conformity, Declaration of Conformity, Attestation of Conformity and instructions have to be observed where applicable. For information see www.pepperl-fuchs.com. |
Parámetros logísticos
| ECCN: | |
| País de origen: | Singapur |
| EAN: | 4050143063222 |
| Peso: | 0,79 kg |
| Longitud: | 0,00 m |
| Anchura: | 0,00 m |
| Altura: | 0,00 m |