View this page in: English
Email: "ucnguBrctvdgcxgt0eqo"
Выберите язык
Запрос цены в 1 клик
Продукт
Pepperl+Fuchs
261243
UC400-F77-EP-IO-V31
Сделать запрос
Pepperl+Fuchs 261243
UC400-F77-EP-IO-V31
Ultrasonic sensor
По запросу. Пожалуйста, отправьте нам письмо, чтобы узнать цену и наличие.
"ucnguBrctvdgcxgt0eqo"
Описание
Single head system, IO-link interface for service and process data, Programmable via DTM with PACTWARE, Continuous distance value via IO-Link process data, Series: -F77, Housing: Polycarbonate, Connection type: Connector plug M8 x 1 , 4-pinfa
Технические характеристики
| Sensing range: | 30 ... 400 mm |
| Adjustment range: | 40 ... 400 mm |
| Dead band: | 0 ... 30 mm |
| Standard target plate: | 20 mm x 20 mm |
| Transducer frequency: | approx. 310 kHz |
| Response delay: | minimum : 10 ms factory setting: 37 ms |
| Sensor cycle time: | ≥ 10 ms (factory setting) ; programmable to 60 s |
| Non-volatile memory: | EEPROM |
| Write cycles: | 300000 |
| LED green: | solid: Power on flashing: Standby mode or IO-Link communication |
| LED yellow: | solid: object in evaluation range flashing: switch point programming, object detected |
| LED red: | solid: error flashing: switch point programming, object not detected |
| Operating voltage: | 10 ... 30 V DC , ripple 10 %SS |
| No-load supply current: | ≤ 40 mA |
| Power consumption: | ≤ 400 mW |
| Time delay before availability: | ≤ 300 ms |
| Interface type: | IO-Link (via C/Q = Pin 4) |
| Device profile: | Smart Sensor |
| Transfer rate: | COM 2 (38.4 kBaud) |
| IO-Link Revision: | 1.1 |
| Min. cycle time: | 2.3 ms |
| Process data width: | 16 bit |
| SIO mode support: | yes |
| Device ID: | 0x300301 (3146497) |
| Compatible master port type: | A |
| Input/output type: | 1 synchronization connection, bidirectional |
| : 0 Level: | 0 ... 1 V |
| : 1 Level: | 2.5 V ... UB |
| : Input impedance: | > 22 kΩ |
| : Output rated operating current: | current source < 2.5 mA |
| : Pulse length: | ≥ 1 ms with external control, low active |
| Synchronization frequency: Common mode operation: | ≤ 109 Hz |
| Synchronization frequency: Multiplex operation: | ≤ 109 Hz / n , n = number of sensors , n ≤ 10 |
| Output type: | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected |
| Rated operating current: | 100 mA , short-circuit/overload protected |
| Voltage drop: | ≤ 2.5 V |
| Repeat accuracy: | ≤ ± 0.1 % of full-scale value |
| Switching frequency: | factory setting: 16 Hz programmable max. 35 Hz |
| Range hysteresis: | 1 % of the adjusted operating range (default settings), programmable , min. 1 mm |
| Temperature influence: | ≤ ± 0.75 % of the end value (with temperature compensation) from 10 minutes after switching on the sensor ; 0,17 %/K (without temperature compensation) |
| Standard conformity: Standards: | EN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 IEC 61131-9:2013 |
| UL approval: | cULus Listed, Class 2 Power Source |
| CCC approval: | CCC approval / marking not required for products rated ≤36 V |
| Ambient temperature: | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature: | -40 ... 85 °C (-40 ... 185 °F) |
| Connection type: | Connector plug M8 x 1 , 4-pin |
| Degree of protection: | IP67 |
| Material: Housing: | Polycarbonate |
| Material: Transducer: | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Installation position: | any position |
| Mass: | 9 g |
| Tightening torque, fastening screws: | max. 0.2 Nm |
| Output: | near switch point: 40 mm far switch point: 400 mm Output mode: Window mode Output logic: normally open |
| Beam width: | wide |
Логистические характеристики
| ТН ВЭД: | |
| Страна происхождения: | SG |
| EAN: | |
| Вес: | 0,00 kg |
| Длина: | 0,00 m |
| Ширина: | 0,00 m |
| Высота: | 0,00 m |