123758
RL28-55-LAS/76a/82b/105/110
Retroreflective sensor
Retroreflective sensor with polarization filter, Visible red light, pulsed LASER light, Ultra bright LEDs for power on, weak signal indication and switching state, Powerful push-pull output, Test input, Not sensitive to ambient light, even with switched energy saving lampsfa
| Effective detection range: | 0 ... 30 m |
| Reflector distance: | 0.3 ... 30 m |
| Threshold detection range: | 42 m |
| Reference target: | MH82 reflector |
| Light source: | laser diode |
| Light type: | modulated visible red light |
| Polarization filter: | yes |
| Laser nominal ratings: Note: | LASER LIGHT , DO NOT STARE INTO BEAM |
| Laser nominal ratings: Laser class: | 1 |
| Laser nominal ratings: Wave length: | 650 nm |
| Laser nominal ratings: Beam divergence: | < 1.5 mrad |
| Laser nominal ratings: Pulse length: | approx. 4.5 µs |
| Laser nominal ratings: Repetition rate: | approx. 6 kHz ... 20 kHz |
| Laser nominal ratings: max. pulse energy: | 4 nJ |
| Diameter of the light spot: | approx. 45 mm at 30 m |
| Angle of divergence: | Emitter: < 0.1 ° Receiver: < 2 ° |
| Ambient light limit: | 50000 Lux |
| MTTFd: | 560 a |
| Mission Time (TM): | 20 a |
| Diagnostic Coverage (DC): | 60 % |
| Operation indicator: | LED green |
| Function indicator: | 2 LEDs yellow, light up when light beam is free, flash when falling short of the stability control, off when light beam is interrupted |
| Control elements: | sensitivity adjustment (Adjustment to < 25% of the effective operating range) , Light-on/dark-on changeover switch |
| Operating voltage: | 10 ... 30 V DC |
| Ripple: | max. 10 % |
| No-load supply current: | ≤ 35 mA |
| Protection class: | II, rated insulation voltage ≤ 250 V AC with pollution degree 1-2 according to IEC 60664-1 |
| Test input: | emitter deactivation with +Ub |
| Pre-fault indication output: | 1 PNP, inactive when falling short of the stability control for 10;s immediately inactive if 4 light beam interruptions take place |
| Switching type: | light/dark on switchable |
| Signal output: | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected |
| Switching voltage: | max. 30 V DC |
| Switching current: | max. 100 mA |
| Voltage drop: | ≤ 2.5 V DC |
| Switching frequency: | 1000 Hz |
| Response time: | 0.5 ms |
| Product standard: | EN 60947-5-2 |
| Laser safety: | EN 60825-1 |
| Protection class: | II, rated voltage ≤ 250 V AC with pollution degree 1-2 according to IEC 60664-1 |
| UL approval: | E87056 , cULus Listed , class 2 power supply , type rating 1 |
| FDA approval: | IEC 60825-1:2007 Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007 |
| Ambient temperature: | -10 ... 50 °C (14 ... 122 °F) |
| Storage temperature: | -20 ... 75 °C (-4 ... 167 °F) |
| Housing width: | 25.8 mm |
| Housing height: | 88 mm |
| Housing depth: | 54.3 mm |
| Degree of protection: | IP67 |
| Connection: | 5-pin, M12 x 1 plastic connector |
| Material: Housing: | Plastic ABS |
| Material: Optical face: | Plastic pane |
| Mass: | 80 g |
| ТН ВЭД: | |
| Страна происхождения: | Vietnam |
| EAN: | 4050143012428 |
| Вес: | 0,12 kg |
| Длина: | 0,00 m |
| Ширина: | 0,00 m |
| Высота: | 0,00 m |